Why does my Hunter ceiling fan light go off and on?

Probably causes are a faulty light kit, the fuse in the light kit has blown, a faulty wall or remote control which could be either the handset or receiver, broken or faulty light switch or just incorrect installation.

How do you reset the LED light on a ceiling fan?





If you ever need to reset your ceiling fan, it’s a simple process that shouldn’t take more than a couple of minutes. Unplug the fan from the wall and wait for 15 seconds, then plug it back in and turn it on with its remote control. This should be enough to get the fan back up and running.

How do I reset my hunter light remote?

Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Press and hold both the ‘FAN’ and ‘LIGHT’ buttons for at least four seconds. This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful.

Why does my light go off and on?

If the flickering is confined to a single source, the light bulb in that lamp or fixture may be defective. Poor connection in your main circuit panel. A more serious cause of your lights turning on and off repeatedly is a problem in the electrical connections in your home.

Why is my Hunter fan remote not working?

Perhaps the most common cause for a ceiling fan remotes not working is either a lack of batteries or dead batteries. If your remote control has an indicator light, check to see if it comes on. If it doesn’t, that’s a good sign that it has a battery problem. Open the remote control battery cover.

How do you reset the remote on a ceiling fan home decorator?





First, you start by turning the fan off using its remote control. Then, you’ll need to wait; some brands ask to wait 15 seconds, though others may require as long as 30 seconds. Last comes the most critical step: in order to reset remote, press and hold the OFF button for about 10 seconds.

How do you troubleshoot a ceiling fan with remote?

If you are using a remote control, check that the batteries are installed properly and are not dead. Check that the dip switches on the remote and receiver are set to the same frequency. If you’re using a wall control, check the power to the breaker from your control and try working your ceiling fan manually.