How do you remove a stuck corroded water valve?

Slowly warm up the body of the water valve with the hairdryer. The heat should help the valve’s body expand enough to allow the moving parts to become mobile once again. Once it warms up, use the wrench to try and loosen it.

Can you spray WD40 on water shut off valve?





Absolutely – WD40 is safe for use on plumbing. So, if you have a stuck water shut-off valve, consider using WD40 to loosen things up. Many folks, especially avid DIYers, have WD40 on hand, so it might save you a trip to the store. WD40 is a non-lethal solution that won’t damage or dissolve the pipe or the threads.

How do you unstick a PVC valve?

Spray the lubricant onto the valve where the valve handle enters the actual valve body and let it sit for about 20 minutes. Then, try loosening the valve by hand again. If it doesn’t move, or is still difficult to turn, tap it lightly with the hammer.

How do you unstick a stuck ball valve?

You can try: Spraying some WD 40 at the stem and letting it sit. Applying a small amount of heat with a torch. Put a wrench on the stem and tap so the vibrations loosen it.

How do you open a stuck main water valve?

Start by turning off the main water shut off valve to the house. Then, spray down the stuck valve with penetrating oil. Penetrating oil is a special type of grease sold at home improvement centers and hardware stores. It has unusually low viscosity, which allows it to penetrate very tight spaces easily.

How do you lubricate a sticky ball valve?





1. Brush silicone lubricant thoroughly over all inside parts of the ball valve before installation, focusing the application around the ball inside and the walls surrounding the bulb. Silicone lubricant won’t harm potable water and is also commonly used to lubricate O-rings inside the pump.

How do you lubricate a valve?


Quote from Youtube video: So it's sitting there will open up the valve oil. And then put a couple drops on the outside of the valve on both sides. Let it drip down in there a little bit.

How do you lubricate a valve stem?

Quote from the video:
Quote from Youtube video: The grease would normally. Run across this channel to the other. Side creating a barrier here of grease so if anything were to pass this o-ring.

Can a ball valve be lubricated?

The lubrication of a ball valve requires a different practice to the lubrication of either a gate valve or plug valve. Field experience has shown that greases and sealants may cause severe problems with the seat and seal arrangement if used regularly during preventative maintenance.

Do ball valves need lubrication?



Ball valves are not very high maintenance parts. Other than worn O rings that seal the ball inside the valve body, keeping the valve clean and free-turning with a little lubrication is all it needs. It’s when a valve looses its lubrication and debris or corrosion builds up that it can become hard to turn.

How do you fix a leaky ball valve?

Shut off the fluid flow to the leaking valve. Remove the handle from the stem. Loosen and remove the packing nut.



Try the following steps to fix a leaking ball valve:

  1. Re-lock the packing gland evenly.
  2. Increase packing material.
  3. Replace old packing materials with new ones.
  4. Replace the valve entirely.