Yes, you can actually move a toilet. Even moving a toilet by a few inches without having to make a new hole in the floor is possible. You can use an offset toilet flange to move the toilet by a couple of inches on any side. This will allow you to use the same wastewater line and in turn help to save you a lot of money.
Is it difficult to reposition a toilet?
Moving a toilet is not so much about moving the actual fixture—in fact, installing a toilet is a simple job that takes less than an hour—as it is about moving the drainage and the water supply plumbing to the new location. Once all of the plumbing is in place, installing the toilet is a relatively easy task.
Can you rotate a toilet 45 degrees?
To answer your question, if there is room to rotate the toilet without hitting the wall and the floor flange spins on the fitting or is threaded and can be spun 45 degrees, yes it should be that simple. Of course a water line mod will need to be made, but that should be simple too.
Can you move a toilet over a few inches?
For the waste water line, an offset toilet flange will allow you to move the toilet a couple of inches in any direction without having to cut a new hole in the floor or reconstruct the waste water pipe.
How do I change the direction of my toilet?
Quote from Youtube video: All right just pull this straight up. I. Just take that side with you. There.
How much does it cost to relocate a toilet?
The cost to move a toilet or sinks can be $2,500-$3,500 per fixture. Plumbing can be a significant cost factor in a remodel when a bathroom floor plan is altered. The toilet is the most expensive to move. Connecting the toilet to the existing sewer line can be a bit tricky for your plumber.
Can you put a toilet anywhere?
On a serious note, it is absolutely possible to install a toilet, even a bathroom as a matter of fact, anywhere in your house. In the past, many homeowners have had the idea of their dream bathroom crushed because the location was simply too far away from the main drain.
Is it possible to relocate a toilet?
Moving a toilet is not a straightforward weekend DIY job, but it is very doable when you involve the professionals. Once the toilet itself is removed, your plumber will have to move the drainage, as well as the water supply to accommodate the new location.
Can a toilet be turned 180 degrees?
Rotating the toilet 180 will depend on two key dimensions. Most toilets are 12″ rough, which means the center of the drain must be at least 12″ from the back wall behind the toilet. The other key dimension is the center of the drain must be at least 15″ from the two side walls. These are FINISHED dimensions.
Can you put a standard toilet in a corner?
You can frame the corner of your bathroom and install a standard toilet if you prefer. However, one benefit of installing a corner toilet is that it won’t protrude into the bathroom space as far as framing a flat surface and using a non-corner toilet.
How do you straighten a crooked toilet?
Quote from the video:
Quote from Youtube video: Straight do the same thing on this. Side i could have used a router but it's such a high speed i just wanted to try it with a with a drill which is a little bit easier.
Does toilet flange have to be perfectly level?
The optimum flange height to aim for is 1/4 inch above the finished floor. This typically allows for almost any type of wax ring to be used and still ensure a good seal. If you recently tiled or changed the bathroom flooring, the flange height is likely less than optimal.
Can you shim a toilet flange?
Quote from the video:
Quote from Youtube video: So you're just going to do it as high as it's needed. And there you have it if you want to clean it up a little bit take a razor blade and cut these plastic shims and then take a bead of caulk.
How do you level an uneven toilet?
Quote from the video:
Quote from Youtube video: I like using plastic shims for this it beats going out there and getting your floor set and try to make a big mess trying to just level it out a little bit these floor shims are able to be stacked.
Should you caulk around a toilet?
Caulk keeps your toilet secure the floor, and avoids any chance of injury or toilet malfunctioning. It’s actually required by the International Plumbing Code to caulk a toilet to the floor, and now knowing the reasoning behind it, why would you not want to?
What do you do if the toilet flange is above the floor?
Quote from the video:
Quote from Youtube video: And bolting it down we did a dry run we always recommend doing a dry run when you are replacing a toilet.
Does toilet flange go inside or outside pipe?
Install a toilet flange on the outside. This can be done with a hammer and chisel. If the flange is cast iron with a rubber gasket, you should be able to remove the cast iron with a hammer and chisel, remove the rubber gasket with a sharp knife, then replace the gasket and the flange.
Can you put a new toilet flange over an old one?
Either slide the new closet flange bolts into the old flange before adding the extender or add them after you adhere the extender to the old flange. Consequently, we chose to add one of the bolts to the old flange first since it was a tight fit. Add metal washers and nuts to the closet flange bolts.
