How do you open the front panel on a Whirlpool Cabrio dryer?
Quote from the video:
Quote from Youtube video: There's one right there so if you take those two screws pop those guys out you can then slide the whole top back. So a lot of folks are saying that there's actually clips right there.
How do I lift the top of my Whirlpool dryer?
Quote from the video:
Quote from Youtube video: The two screws near the opening. Next insert a putty knife under the front of the main top to release the two spring clips. And rotate the top up disconnect.
How do you remove the front panel of a Whirlpool front load dryer?
Quote from the video:
Quote from Youtube video: Top with the screws removed simply grasp the size of that top. And pull it back about a half to three quarters of an inch. Then we'll unhook some tabs at the front and we can just lift it right off.
How do you open the front of a Whirlpool dryer?
On the front of the dryer, press out on the two end tabs connecting the console to the dryer’s front. Pull up on the console to unhook it from the front, then you should be able to easily slide it away from the dryer. Open the dryer door and use a small putty knife to pry the door switch off of the dryer.
How do you clean the lint out of a Cabrio dryer?
Quote from the video:
Quote from Youtube video: This all right here make sure you clean this make sure you get all the lint as possible it becomes if it's not coming up damp your fingers a little. Bit. All right and then pull out the lint.
How do I take the top off my dryer?
Quote from the video:
Quote from Youtube video: First thing we have to do is lift up the lint screen cover to gain access to the two screws if you have the type of lint screen that has the cover built into it just pull it out and remove the screws.
How do you open a Whirlpool dryer cabinet?
Quote from the video:
Quote from Youtube video: Your first step is to detach the control panel depending on your model you will either insert a putty knife under the panel to release the two clips or you will pull off both plastic end caps.
How do you clean a Whirlpool Cabrio dryer vent?
Quote from the video:
Quote from Youtube video: So you have access to the vent hose. So you can remove it and clean it. Once it's off you can stick your long handle flexible brush inside the vent hose. And pull out as much lint as possible.
How do you take apart a gas dryer?
Quote from the video:
Quote from Youtube video: Before you attempt this be sure to unplug the power cord to access components inside the dryer console use a quarter inch socket or nut driver to unthread the upper rear screws securing the console.
How do I open my front load dryer?
To open the front of the dryer, start with the lower kick plate panel. Unscrew this and take it off. Then support the bottom of the tumbler drum with a couple of blocks or bricks so that, when you pull the full front of the dryer off, the drum won’t drop.
How do I clean the lint out of my front load dryer?
Instructions
- Remove lint screen from the dryer and wash in warm soapy water (see notes below)
- Use a screwdriver to remove the “cover” from the lint filter compartment and thoroughly clean with vacuum and microfiber cloth.
- Use a lint vent cleaning brush to loosen lint and debris inside the dryer.
How do you clean lint out of a dryer?
How to deep clean a lint screen every six months:
- Use a lint roller to remove lint from the screen.
- Wet both sides with hot water.
- Scrub with a nylon brush or toothbrush in a mixture of hot water and liquid detergent to remove any buildup.
- Rinse with hot water.
- Dry thoroughly.
How do you get to the lint trap on a Whirlpool Cabrio dryer?
Quote from the video:
Quote from Youtube video: Open the dryer door and use a Phillips head screwdriver to unthread the screws securing the front panel to the bulkhead. Using the quarter inch socket or nut driver unthread the upper mounting.
How do you deep clean a dryer lint trap?
Cleaning a Dryer Lint Trap
Take the lint trap screen to the sink, and wash it with warm soap and water. While the lint trap dries, use your vacuum to clean the slot the lint trap slides into. Use a long, narrow vacuum extension to reach as far down as possible. You might be surprised by how much lint you find.
How do I clean the lint out of my Whirlpool dryer?
To deep clean the lint screen, roll lint off, then wet both sides with hot water. Scrub with a nylon brush, hot water and liquid detergent to remove buildup. Rinse the screen with hot water and dry thoroughly.
Where is the lint trap in Whirlpool Cabrio washer?
Inside the center agitator: If you have a top-loading washer, inspect the center agitator. The cover may be removable, revealing a lint trap inside. At the end of the drainage hose: A small mesh screen may be fitted onto the end of the hose that drains water out of the machine.
Where is Whirlpool lint trap?
Each Whirlpool dryer is equipped with a lint trap located inside on the rear wall of the dryer. The lint that accumulates in these traps should be removed each time the dryer is operated. Failure to remove the lint reduces the efficiency of the dryer and could present a fire hazard.
How do I clean the inside of my dryer vent?
How to Clean Out a Dryer Vent in 7 Simple Steps
- Gather Your Cleaning Supplies. …
- Pull the Dryer Out From the Wall, Unplug It, and Disconnect the Duct. …
- Vacuum the Inside of the Vent. …
- Connect the Flexible Rods in Your Dryer Duct Cleaning Kit to Your Power Drill. …
- Turn On the Drill and Let the Brush Work Its Magic.
How do you tell if your dryer vent is clogged?
The Warning Signs and Dangers of Clogged Dryer Vents
- It takes longer than usual to dry your clothes. …
- You notice a burning smell. …
- Your clothes are hot to the touch at the end of a load. …
- You can see lint or debris in the dryer hose or around the outside dryer flap. …
- You haven’t cleaned out your vents in over a year.
How do I know if my dryer vent needs cleaning?
8 Signs You Need to Clean Your Dryer Vent
- Clothes take longer than normal to dry. …
- Clothes are unusually hot to the touch. …
- The room is warmer than normal when the dryer is running. …
- You’ve noticed burning smells. …
- The lint flap isn’t opening. …
- The dryer tells you there’s a problem. …
- The dryer stops working.
