If your GFCI is tripping often, it’s possible that you’re plugged into an overloaded circuit — which, if it goes unchecked, could lead to a fire. If you’ve got any other major home appliances or electronics plugged into the same circuit as your fridge, move them to a different outlet before calling a professional.

Why is my refrigerator tripping my GFCI outlet?

This is usually caused by multiple appliances being plugged into the same circuit. To avoid this happening, make sure that your refrigerator has a dedicated circuit, which you can do by plugging your refrigerator into an alternative power outlet and seeing if it still trips.

Why does my refrigerator keep tripping my outlet?

If your refrigerator trips often, then it is likely due to the compressor. Every time your compressor turns on to run the cooling cycle, it will trip the breaker. When this happens, it is typically due to a grounding issue with the compressor that is causing the part to essentially become overloaded with electricity.

How do you fix a short circuit on a refrigerator?

Quote from the video:
Quote from Youtube video: We need to check the condenser fan motor the condenser fan motor often fails because it works very hard to remove heat pry this tab to remove the connector connect the meter probes to the motor.

What to do if GFCI keeps tripping?

If there’s water in the GFCI, trip the breaker and use a blow dryer to dry out the receptacle box. Once the outlet is completely dry, reset the GFCI. Unplug everything from the outlet and see if the GFCI stops tripping. Plug everything back in one at a time to see which appliance is causing the breaker to trip.

How do I know if my GFCI is bad?

You can use a two-prong voltage tester to test a GFCI outlet you suspect is bad, but it’s better to use a three-prong tester. This inexpensive device will tell you if a wiring problem is causing the outlet malfunction or if the outlet is bad.

Why does my freezer keep tripping the breaker?

If the insulation is frayed or the wiring is damaged, it can cause short circuits or surges. This will trip your breaker. The same thing goes if the prongs on the plug are rusty, wobbly, or broken. If you find an issue with the cord, we recommend just replacing it.

Can an overload trip a GFCI?

Overloads don’t trip a GFCI.



If there was an overload, it would trip the actual circuit breaker. Since this is a GFCI/receptacle (as opposed to a GFCI/breaker) and the GFCI trips, that is a GFCI problem – 100% – and not an overcurrent situation.

Can a bad breaker cause a GFCI to trip?

Hi Amps – When installed a GFCI breaker carries a set amount of amperes which may sometimes be too low to facilitate some electrical loads and because of this tripping can occur. Faulty Breaker – Another very common possibility that will initiate a GFCI breaker tripping is a faulty breaker.

How often do GFCI outlets go bad?

about 10 years

Electrical safety check



All GFCI outlets have one little-known flaw: their circuitry eventually wears out, usually after about 10 years, at which point they no longer function properly.

Can a GFCI be bad and still work?

GFCI outlets can also be wired wrong, which will cause newer units not to work. The older receptacles usually work when wired backward but will not offer proper protection, and the “Test” button might not cause the outlet to trip.

Can a bad GFCI cause a fire?

There are instances in which the rapid tripping of a GFI will not prevent an electrical fire, even though the GFI has detected and reacted to a ground fault. If two wires, hot and ground, touch such that arcing occurs, a readily flammable or explosive atmosphere can still be ignited by the arcing.

How often should GFCI outlets be replaced?

between 7-10 years

GFCI outlets last between 7-10 years but can sometimes fail after only 5 years. Since GFCIs are one of the most important safety features in your home, it’s important to check your GFCIs monthly and every home should have its GFCIs tested and replaced if necessary every 7-10 years.

Is there a difference between GFI and GFCI?

Ground fault circuit interrupters (GFCI) and ground fault interrupters (GFI) are the exact same device under slightly different names. Though GFCI is more commonly used than GFI, the terms are interchangeable.

Can a refrigerator be plugged into a GFCI outlet?

However, GFCI’s are prone to a phenomenon called “phantom tripping,” meaning that they sometimes activate -shutting power off to the circuit – under normal, everyday voltage fluctuations. So freezers and refrigerators should never be plugged into GFCI’s.

Should a refrigerator be on a GFCI circuit?

In a dwelling unit (residential), GFCI protection is only required for kitchen receptacles that serve the countertop surfaces. There’s no requirement to GFCI protect receptacles that serve a refrigerator. Unless the fridge is plugged into a countertop receptacle.