How do you loosen a stuck compression fitting?

Quote from the video:
Quote from Youtube video: Once the compression that is mostly cut through take the flathead screwdriver. And pry the opening of the nut further apart.

How do you remove corroded compression fittings?

Turn the compression nut counterclockwise relative to the male part of the fitting with another pair of adjustable pliers. When you are removing a shutoff valve, this means turning the nut clockwise with respect to you. Once the nut is loose, unscrew it by hand until the fitting separates.

How do you remove a compression fitting from a copper pipe?

Disconnect the compression nut that fits around the water supply pipe by gripping the valve with one pair of channel-lock pliers and turning the compression nut with another pair of pliers. Slide the valve body off the end of the water pipe, then slide the brass compression ring and compression nut off the pipe.

Can you overtighten a compression fitting?

Hold the compression fitting body tightly with a pair of grips and tighten the nut with a spanner. Its often said in the trade to not over tighten a compression fitting, leaving you more thread in the case of a leak and not distorting the olive or fitting. Generally a nut will need one whole turn after hand tightening.

How do you remove a stuck ferrule from a copper pipe?

Grip the nut closest to the wall or floor with a pair of pliers. Hold onto the front of the angle stop so it stays in place. Turn the nut clockwise to loosen it from the angle stop. Then you can turn the nut by hand until it detaches from the angle stop to reveal the ferrule wrapped around your pipe.

How do you use olive removal tool?

Removing 15mm olives

  1. Step 1 – Insert spindle. Insert the spindle into the 15mm body. …
  2. Step 2 – Retract spindle. …
  3. Step 3 – Fit olive puller onto pipe. …
  4. Step 4 – Screw body into compression fitting. …
  5. Step 5 – Rotate spindle. …
  6. Step 6 – Unscrew nut. …
  7. Step 7 – Remove olive puller. …
  8. Step 8 – Remove olive.

Is it OK to reuse compression fittings?

Reusable Compression Fittings:

They are safe to be reused and apply to half the movement of the pipe outward from the fitting. In hydraulic process, compression fittings basically assure some secure fit in pipe connections. Leaks are only possible if they are not properly installed to each end of the fluid line .