The only time they’re a concern is when there’s significant moisture contact, but then there are usually other problems of larger magnitude. Now if you’re asking because you’re putting in full-thickness (1″ or better) hardwood treads, then yes, you’d remove those.

How do you remove particle board stair treads?

You’d need to wedge the pry bar’s flat end beneath the top stair tread and hit its other end with a hammer. Then, you would nudge the bar between the stair tread and stringer, which is the vertical support beneath it. Lift the bar until the tread comes up and off.

Can you put new stair treads over old treads?

Retro-fitting stair treads is the simplest solution for a DIY’er intent on installing hardwood treads over an existing flight of stairs. High-quality prefinished stair treads are made of solid edge-glued wood—not a veneered or engineered material—and can be used to “cap” or reface an existing tread.

Can you use particle board for stair treads?

Durable, budget-friendly particle board is an ideal tread material for carpeted stairways. Durable, budget-friendly particle board is an ideal tread material for carpeted stairways.

Can you install risers after treads?

When installing stairs, install the riser first, and then the tread. Start at the bottom of the stairs and work your way up, alternating risers and treads. The back of each tread will sit flush against the riser. Treads and risers fasten with construction adhesive to the subfloor.

How can I redo my stairs cheap?

Quote from the video:
Quote from Youtube video: So I start off by eliminating the connection between the drywall and stairs by adding a 1-inch piece of trim to the top of the stringer.

Do you install risers or treads first?

Do work at least one riser ahead before installing treads. Installing two risers is one way to ensure proper strength and performance. The important thing is to remember to install riser, tread, riser, tread or install the risers first.

How much should a stair tread overhang the riser?

The acceptable tread overhang requirements according to the IRC protrude 3/4″ to 1-1/4” past the face of the riser or riser line to ensure the going is 10-inches. The overhang increases the foot placement space on the tread, but doesn’t change the depth of the going, or tread depth under the IRC definition.

Do you stain stair treads before or after installation?

Staining and varnishing hardwood treads prior to installation is recommended, especially in this case where we have stone or tile risers. We purchased 11.5-in x 48-in unfinished red oak stair treads from Lowes for about $30 each. Treads should be laid out, sanded if needed, and cleaned prior to applying stain.

Do stairs need risers?

Standard Stair Riser Height Requirements



OSHA 1910.25(c)(2) requires standard stairs to have a maximum riser height of 9.5 inches (24 cm). IBC 1011.5. 2 requires that stair riser heights shall be 7 inches (178 mm) maximum and 4 inches (102 mm) minimum.

Why is nosing required on stairs?

The stair nosing can provide extra safety to your staircase. It overhangs the top of the tread and provides extra space for you to step on. It also helps protect the edge of your treads from getting damaged and wearing down over time.

What is code for a stair tread?

Stair Treads



Stair riser heights shall be 7 inches (178 mm) maximum and 4 inches (102 mm) minimum. Stair tread depths shall be 11 inches (279 mm) minimum. The riser height shall be measured vertically between the leading edges of adjacent treads.