How do you remove a pivot rod from a sink stopper?
Get underneath the sink and look where your pivot rod is connected to the clevis strap. Disconnect the pivot rod from the clevis strap by squeezing the two end of the spring clip together and sliding it out. If you cannot do it with your hands, use a pair of pliers.
How do you remove a pivot nut?
Quote from the video:
Quote from Youtube video: Place a container under the drain. Turn the pivot rod nut counter clockwise. If it's a plastic one. You should be able to do this by. Hand.
How do you remove a sink stopper that is attached?
To remove the stopper, you’ll need to go under the sink and unscrew the pivot rod arm connected to the sink drain pipe. You may need pliers or a wrench to help twist the arm off. Pull out the arm, including the round plug attached to it. Then, return to the sink and pull the stopper out.
How do you get a stuck locknut out of a sink?
- Spray bathroom cleaner on the stuck nut and wipe up with a towel or rag. …
- Spray the nut with penetrating lubricant. …
- Tap the side of the lock nut with a hammer. …
- Clamp a pair of locking pliers around the nut and lock into place. …
- Heat the nut with a plumber’s torch. …
- Slip a nut splitter over the lock nut.
- PREPARE SINK. …
- LOOSEN THE SPRING CLIP. …
- TAKE OFF THE SPRING CLIP AND CLEVIS STRAP. …
- UNSCREW GASKET HOLDING PIVOT ROD. …
- REMOVE PIVOT ROD. …
- EXCHANGE OR CLEAN PIVOT ROD. …
- EXCHANGE OR CLEAN DRAIN STOPPER. …
- REPLACE THE DRAIN STOPPER.
How do you replace a pivot rod in a bathroom sink?
STEP-BY-STEP INSTRUCTIONS:
How do you loosen a stuck PVC P Trap?
Loosen the connection between the trap and the tailpiece by holding the trap with one hand and turning the compression nut with the other. Turn the nut counterclockwise with respect to the tailpiece. It may take a certain amount of strength, but you should be able to turn it.
How do you remove a glued P-trap?
Mark the PVC pipes attached to each side of the P-trap three inches away from where they join to the trap. Make a straight perpendicular cut through the sewer pipes at both marks, using a hacksaw. Remove the trap. Scrape off all plastic burrs from the cut pipe ends with a utility knife.
How do I remove glued PVC pipe?
Quote from the video:
Quote from Youtube video: When you found the right one heat it thoroughly for around one minute and put it inside the pipe as such. What this does is it heats up the glue just enough for the pipe to unstick.
How do you loosen plastic plumbing pipes?
Quote from the video:
Quote from Youtube video: So you want to grip it just enough that you have a hold on it. Then I take my pair of pliers. And I'll grip the other one and just give it a little twist. And they should come right apart.
How do you unstick plastic threads?
Run the Lid Under Hot Water
When a lid on a partially used jar is stuck, it could be glued shut. If you can’t loosen it using a rubber glove, turn on the hot water and let it run until it reaches its maximum temperature. Hold the lid under the water for about 30 seconds.
How do you loosen PVC pipe under sink?
Quote from the video:
Quote from Youtube video: Using your rag place it in your hand and grip the p-trap. Now grip the other side and you're doing this so you don't actually snap the pipe. And just turn it loosen up a little bit now do the other.
