Why does my shower go cold for a few seconds?

The Showerhead Mixer Valve Is Broken





If it’s broken, it won’t be able to add enough hot water to the cold water to keep it hot for an extended period of time. A professional plumber can easily replace the broken mixer valve and have your shower back up and running in a few minutes.

What causes shower water temperature to fluctuate?

If your water temperature fluctuates, the pressure-balancing valve might be to blame. Your pressure-balancing valves open and close depending on your water flow in your plumbing system. If cold or hot water levels drop, a broken pressure valve could cause a drop in water pressure.

Why does my shower go cold after a while?

Your shower has faulty pressure-balancing valves.

Faulty valves are common causes of temperature fluctuations in the shower. The pressure-balancing valves, also known as thermostatic mixing valves (TMV), blend cold water with hot water to provide constant and safe shower temperatures, preventing scalding.

Why does my shower not stay hot for long?





The lack of hot water for the shower and elsewhere in the home may be down to several reasons. It could be faulty parts in the water heating unit, an obstructed flue, the build-up of sediment or a malfunctioning temperature control.

Why is my water cold in my house?

Perhaps the most common reason for water to remain cold in a busy home is an empty tank. Water heaters work hard to heat an amount of water which fills the tank, but this tank has a limited capacity.

How do I stop my shower going cold?

Tips to Keep Your Shower Running Hot

  1. Determine what’s causing your cold showers.
  2. Diagnose and fix any problems with your water heater.
  3. Correctly install a new, water-efficient toilet.
  4. Perform shower valve repairs, such as replacing a bad cartridge.
  5. Install or adjust scald-guard valves and low-flow showerheads.

How do you fix inconsistent water temperature?



Faulty Water Heater Dip Tube Causing Inconsistent Temperatures

  1. Prep the Water Heater. Turn off the gas or electric supply to the water heater. …
  2. Remove the Vent Stack. …
  3. Unscrew and Separate Union. …
  4. Remove the Union Fitting. …
  5. Remove the Dip Tube. …
  6. Prepare the New Dip Tube. …
  7. Install the New Dip Tube. …
  8. Finish Installation.

Why is my water only hot sometimes?

Sediment Is Affecting the Heating Element



The resulting sediment can reduce the lower heating element’s effectiveness, causing only lukewarm to flow from your hot water tap. To fix this problem, make sure your hot water tank is flushed annually to remove any minerals.

Why is my hot water intermittent?

There are usually only three main reasons for intermittent hot water (all caused because of scale): Diverter valve is jammed with scale. Micro switch is stuck because of scale deposits. Domestic heat exchanger could be scaled up.

Why does my water only stays hot for a few minutes?

Water Heater Runs Out Of Hot Water Quickly: Possible Reasons Why. As mentioned above, several things can cause a home’s hot water supply to run out faster than it should. The three most common culprits are sediment build up, a faulty heating element and a broken dip tube.

How do you check a water heater element?

How to Test the Element

  1. Shut off the Power. …
  2. Remove the Metal Covers. …
  3. Remove the Insulation and Plastic Covers. …
  4. Locate the Heating Element. …
  5. Verify the Electricity Is Off. …
  6. Check the Heater Element With Your Multimeter. …
  7. Reassemble the Water Heater.


Why does my shower go cold after 10 minutes?

If you’ve noticed that your hot water is suddenly turning cold after a very short amount of time, the most likely cause is a broken dip tube inside your hot water heater.