How do you wire a Legrand motion sensor switch?
Quote from the video:
Quote from Youtube video: And remove the mounting screws connecting the existing switch to the mounting. Box next disconnect the existing wires by loosening the terminal screws on the existing switch. Now.
How do you adjust a Legrand occupancy sensor?
Quote from the video:
Quote from Youtube video: And what we do is hold the button for 10 seconds. Until we see a burst of five quick blinks from the led.
How do you wire an occupancy sensor?
Quote from the video:
Quote from Youtube video: Now you can disconnect all the wires from the switch. Next you'll attach the occupancy sensor to the wall box wires. If you are installing a single pole sensor you'll see two black wires a bare wire.
How do I program my Legrand lights?
Quote from the video:
Quote from Youtube video: Account enter your zip code to identify the sunrise and sunset timing for the scheduling. Feature. Next scan the code on your device to pair it with the app.
How do you adjust an automatic light switch?
Quote from the video:
Quote from Youtube video: The range by turning the dial right. Towards 4 or 100%. Walk around the room to test the time delay use the knob on the left to adjust in any increment.
How do you wire a 3 way occupancy switch?
Quote from the video:
Quote from Youtube video: Important you do not mix them up now the other black wire will be connected to this black wire then brass screw now the blue wire will be connected on the red wire.
How do you program a light sensor switch?
Quote from the video:
Quote from Youtube video: How much ambient daylight is enough before it decides whether to turn on or not turn on the instructions. Say if the switch turns on when there is enough natural light or if the switch.
How do you stop motion sensor lights from turning off?
How To Make A Motion Sensor Light Stay On?
- Quickly Switching The Motion Sensor ON And OFF. …
- Hardwire Bypass With An Additional Manual Switch. …
- Use A Motion Sensor With Stay On / Manual On Feature.
Why does my motion sensor light not turn off?
If your outdoor security light won’t turn off, it’s most likely because of one of these problems: The sensitivity settings are too high. The duration settings are too high. It’s stuck in auto mode.
How do I reset my motion light stays on all the time?
Reset your Motion Detector – To reset your motion light, unplug it from its power source for a full 10 seconds. Plug it back in and allow it to come back on. This should reset your light and turn off the auto-on function.
How do you troubleshoot a motion sensor light?
Troubleshooting Motion Detector Lighting
- Take Aim. Most motion detecting light fixtures allow the motion detector to be aimed at a specific area. …
- Don’t Be So Sensitive. Motion detectors also typically come equipped with sensitivity settings. …
- Not Too Long, Not Too Short. …
- Clean Up Your Act. …
- Don’t Interrupt.
Why did my motion light stop working?
Wipe the sensor with a clean, soft cloth—something that doesn’t scratch glass and plastic surfaces. Check and/or change the bulb. If the sensor is clean and clear, but the problem persists, you might examine or change the bulbs in your motion light, since they last a while, but will wear out over time.
Why do motion sensors fail?
Most models perform as intended, but power outages, inclement weather and age can cause them to fail. Use these tips to reset your motion sensor lights, and in most cases, they’ll be working correctly again in a matter of minutes.
How do you reset a motion sensor?
Quote from the video:
Quote from Youtube video: When the light comes on turn the switch to the off position then wait 5 to 7 seconds before turning it on again. The light should now be off and the motion detection unit reset.
How do you test a motion sensor?
Walk across the sensors field of view, the LED will illuminate when it detects motion. It is best to walk across the sensor, rather than directly towards the sensor. The sensor will repeat this process of waiting 30 seconds then lighting up as it sees motion. It will stay in the test mode for 3 minutes.
