What size are the correct fittings for 1 1/4″ ABS pipe?

Do they make 1 1 4 ABS pipe?

Ipex ABS Cell Core Pipe – 1 1/4-in Dia x 12-ft L – For Drain Waste Vent System – Solvent Welded.

What is the OD of 1 1 4 ABS pipe?

ABS Schedule 80 Sizes & Dimensions

How do you determine your fitting size?

Measuring Nominal Pipe Size



For male pipe threads, be sure to measure the outside diameter at the widest point of the threads. For female pipe threads, measure the inside diameter at the widest point of the threads. You can then use these measurements to find the right size in a nominal pipe size conversion chart .

What size is ABS drain pipe?

ABS pipe is available in 1¼”, 1½” diameter, 2”, 3”, 4” and 6” with solid wall or cellular core wall constructions, which can be used interchangeably.

Why is ABS pipe no longer used?

The State of California has banned the use of “regrind” or recycled plastic resin for use in ABS drain-waste-vent pipe. The new law stemmed from major problems with pipe failure of recycled-content ABS pipe made by several companies during the 1980s.

How do you connect ABS pipe?

Quote from the video:
Quote from Youtube video: You should have a band to glue all the way around if you think you've got a little too much glue you can remove some off again band the glue around the inside.

Do you use Teflon tape on ABS fittings?

Threaded ABS Joints



Never use any petroleum based thread sealant compounds(such as pipe dope) as it will deteriorate the pipe, use only Teflon tape or other ABS approved thread sealants; Never over tighten the joint as the fittings are prone to cracking, a good rule of thumb is one full turn past hand tight.

How do I join ABS plastic?

ABS can be joined using common adhesives including “model airplane cement”, ABS “pipe cement”, all grades of cyanoacrylates including liquid and gel versions of the products, epoxies which harden in 90 seconds to 5 minutes or cure slowly, polyurethanes, and structural acrylic adhesives.

What are ABS fittings?

Drain, waste and vent fittings (DWV) made from acrylonitrile-butadiene-styrene (ABS) are used for residential and commercial sanitary systems. ABS is an excellent high strength, high impact thermoplastic material ideal for use in residential and commercial drain, waste and vent systems.

Are ABS and PVC threads the same?

ABS is always black while PVC is white– and easy way to see the difference quickly. PVC piping offers more flexibility, but ABS is a stronger piping and can resist a higher shock. For underground, ABS is great as it can handle extreme cold and can warp if it is in direct sunlight.

How is ABS pipe measured?

Quote from the video:
Quote from Youtube video: When we're measuring our pipe. We need to use the outside diameter of the pipe the measured diameter of the pipe in millimeters.

What is stronger PVC or ABS?

PVC pipe is more flexible than ABS, while ABS is a bit stronger and can resist a higher shock or impact. Additionally, PVC has an advantage in that it’s better at muffling the sound of water as it flows through the pipework.

Will PVC fittings work on ABS pipe?

Most plumbing codes don’t allow ABS pipe to be solvent-welded (glued) to PVC.

Does ABS pipe need primer?

Primer: Primer is used to clean and soften the surface of the plastic to ensure a good solvent weld. It’s used with both PVC and CPVC, but is not required with ABS.