The main reason that your Whirlpool fridge/freezer won’t cool is often debris built up on the condenser coils. However, faulty fans, blocked vents, and even a packed fridge can affect how well the unit works. Check and clean the coils before unplugging the unit and testing internal parts for issues.

How do I make my Whirlpool freezer colder?

To make the Freezer colder, adjust the control to the next higher setting. To make the Freezer less cold, adjust the control to the next lower setting. Allow the Freezer to cool six to eight hours before filling with frozen food. Let the freezer cool overnight before adding large amounts of unfrozen food.

Why is my freezer not cold enough?





Defrost system problems, dirty condenser coils, fan failures, leaky door gaskets or control problems can lead to your freezer not getting cold enough. Although you may see the cooling problem start in the freezer, you’ll typically soon find the refrigerator and freezer not cool enough.

How do I reset my Whirlpool freezer compressor?

4 steps to reset a refrigerator compressor

  1. Unplug your refrigerator. …
  2. Turn off the refrigerator and freezer from the control panel. …
  3. Reset your freezer and fridge temperature settings. …
  4. Wait for the refrigerator temperature to stabilize.


Why is my freezer running but not freezing?

Problem 1: Freezer Not Freezing



If your freezer won’t freeze, most likely the condenser coils are dirty which reduces the overall cooling capacity of the freezer. Evaporator fan motor is malfunctioning, and since it’s in charge of circulating the air throughout the freezer, this will need to be resolved, pronto.

What should a Whirlpool freezer temperature be?





The recommended freezer temperature to keep your food safe is at or below 0°F (-18°C), but your freezer may need to be set higher or lower depending on its environment and other factors. The typical freezer factory setting on Whirlpool® refrigerators is a great starting point at the recommended 0°F (-18°C).

Why is my Whirlpool fridge too cold?

If the temperature control thermostat is not working properly, it may cause the refrigerant system to run longer than necessary. As a result, the refrigerator will be too cold. To determine if the thermostat is defective, rotate the thermostat from the lowest setting to the highest setting and listen for a click.

How do you fix a freezer that is not freezing?


Quote from Youtube video: You should check to see if there are any obstructions preventing the fan blades from turning. If the blades do not spin freely it's likely that the motor bearings are worn out.

How do I clean my condenser coils in my freezer?

Clean the coils with a special refrigerator coil cleaning brush to loosen the dirt and dust. Vacuum the coils as you brush. Be careful not to bend the fan blades. A gentle brushing will do the job.

Where is evaporator fan in freezer?



Evaporator fan motors are usually located towards the back of the refrigerator or freezer compartment behind a panel. Typically one will need to remove all the shelves and drawers so as to access this rear panel.

How much should freezer temperature fluctuates?

It should be between -5 and +8 degrees Fahrenheit in the freezer section of a self-defrosting model or 5 to 7 degrees Fahrenheit in the freezer section of a manual defrost model.

Why is my freezer temp fluctuating?

As said, temperature fluctuations are quite normal and will occur to a greater or less extent in all types of equipment. The temperature rises and falls in the freezer due to the control that the freezer is equipped with. Based on the setting, the freezer will cool until it reaches a limit value.

Why does my freezer get warm sometimes?



Like a regular fridge, a faulty evaporator fan or frozen evaporator coils can cause a warm fridge compartment, even if the freezer compartment remains cold. A problem with your freezer’s defrost system can cause your fridge’s evaporator coils and other components to ice over, preventing it from cooling correctly.