Wiring two motion sensors from separate locations to control a bank of lights in between both?

Can you wire 2 motion sensors together?

The way to wire two or more motion detectors to control one or more outdoor light fixtures is to wire a control circuit where the motion detectors are connected to one control relay, and the control relay will turn on the light fixtures. Using this method, the light fixture is activated by either motion detector.

Can you connect two motion sensors to light?

A light can be controlled with more than one motion sensor. Whether it’s for security, convenience or a way to be hospitable to unexpected visitors, a motion sensor wired to a light will brighten up the approach to your house when guests or intruders come in range.

How do I connect two motion sensors together?

Quote from the video:
Quote from Youtube video: Power from the black line into the motion detector. It's sensing that there's motion the light turns on if however you're slaving them together like I am so that you can have one master.

Can motion sensors be wired in series?

Normally closed wiring is usually used when wiring a motion sensor. This may be referred to as Series wiring. The motion sensors will be wired in series if they are connected to the same zone. It is possible to use an end of line Resistor with your motion detectors.

How do you wire a motion sensor to an outside light?

Run the wires into the fixture and screw the motion detector into your light fixture. Connect the hot wire from the house to the motion detector black, the red wire to the hot wire (black in the US) of the light, and tie the neutral wires together. Adjust the sensitivity as needed, button it all up, and call it done.

Can you put 2 motion sensor on a three way switch?

When using in a 3-way application use one sensor and one standard 3-way switch. Cannot be used with another sensor, or in a 4-way application.

How do you hook up two outside lights?

Quote from the video:
Quote from Youtube video: Work you're also going to need an sds drill. And some sds drill bits to go through the wall. Obviously you're going to need a ladder.

Can you have 2 PIR sensors to 1 light?

Hi, In theory-yes-using 3 core (plus cpc), any one pir activating will bring all the lights on-bearing in mind the total load!,most pir’s will switch up to 1000 watts, so dependent you may require a relay.