Can Ser cable be used outdoors?
Using SER Cable to Feed Distribution and Sub-Panels
More specifically, many customers are using our SER as a service entrance feeder cable from utility poles to their sub-panels when distributing power to an area outside the home (like a detached garage).
Does Ser wire need conduit?
Technically SE cable ran indoors is treated as NM cable…. I’d recommend metallic flex though if a conduit is to be used. Show activity on this post. SER is fine.
How do you secure a ser cable?
Nonmetallic-sheathed cable shall be supported and secured by staples; cable ties listed and identified for securement and support; or straps, hangers, or similar fittings designed and installed so as not to damage the cable, at intervals not exceeding 1.4 m (4½ ft) and within 300 mm (12 in.)
What is the difference between SEU and SER cables?
Basically, SER is a round service electrical cable that typically has up to four conductors and a bare neutral. The cable is designed to use above the ground in feeder panels and branch circuits. SEU is an unarmored Style U flat service electrical cable with two-phase conductors and a concentric neutral.
Is Ser cable sunlight resistant?
Type SE, Style SER Service Entrance Cable. 600 Volt. Individual Conductors Rated XHHW-2 or THHN/THWN. Jacket and Individual Conductors Sunlight Resistant.
Can I use aluminum wire to feed a sub panel?
Safety concerns caused aluminum wire to be banned from use in branch circuits years ago, but it is a common option for feeding main service panels and subpanels.
Can Ser go in conduit?
Yes, you can run service-entrance cable (SER) in conduit, but it can’t be run underground, either in or out of conduit.
Can I use PVC conduit for service-entrance?
Exposed — PVC conduit is permitted to be used for exposed work. PVC conduit used in an area subject to physical damage must be identified for the application [Sec. 352.10(F)]. Schedule 40 PVC conduit is permitted for exposed locations where not subject to physical damage.
How do you install SER cable?
Quote from the video:
Quote from Youtube video: It's got all those green screws in it you can double tap those babies you can put two in each one of those that's why it's shorter. But the neutral bus you can only put one wire.
How do you wire a service entrance panel?
Quote from the video:
Quote from Youtube video: And there's a piece of two-inch PVC conduit connecting the two boxes. We use the lock ring as well as a this plastic bushing that's required.
Where can ser cable be used?
SER is a type SE (service entrance), Style R (reinforcement tape) cable, used as an above ground service entrance cable, a panel feeder and in branch circuits. It is most often used to deliver power from the service drop down to the meter base, and from the meter base to the distribution panel board.
