You can’t put 100amps on 8 gauge wire. You can’t mix line voltage and coax in your 3” pipe.
What size wire do I need to run a 100 amp sub panel?
The cable must have a wire gauge sufficient to the amperage of the subpanel—a 100-amp subpanel requires #4 copper wires or, more commonly, #2 aluminum wires, for example. (Aluminum is often used for feeder cables because the cost is typically much lower than that of copper wires.)
Can you use stranded wire for sub panel?
A: Yes, this size is fine for a 100 amp subpanel.
How many amps will a number 8 stranded wire carry?
55 AMPS
#8 Gauge THHN Copper Stranded Wire is the most popular single conductor copper wire we carry and is RATED FOR 55 AMPS @ 90°C.
What size wire do I need to run 100 amp Service 100 feet?
If you check the wire size chart (you have the link in the introduction), the #0 AWG wire (also known as 1/0 AWG wire) has 150 ampacity. That means that #0 AWG wire is the perfect size wire for 100 amp service 100 feet away.
What size wire do I need for 100 amp service 300 feet away?
for 300 feet for 100 amp rated service I would use Aluminum direct burial 1/0-1/0-1/0-1/0, the forth can be as low as #4 for the ground (but also in conduit, even if in conduit must still be rated underground wire and required by code also) Also note the size wire the breaker can handle, cannot cut strands to make fit,
What size copper wire is rated for 100 amps?
A 100 amp sub panel wiring size requirement is #4 for copper wires and #2 for aluminum wires.
What is 8 3 stranded wire used for?
NM-B is primarily used in residential wiring as a branch circuit for switches, outlets and other loads. NM-B may run in air voids of masonry block or tile walls where locations are not damp.
Can stranded wire be used in breaker box?
When installing a circuit breaker to protect a circuit, many installation factors must be considered. One of these decisions is to choose the best suited means of connecting the circuit breaker to the load. For molded-case circuit breakers, the most common connection means are solid and stranded wire conductors.
Can I use stranded wire instead of solid?
Stranded wire has proved to be more flexible than the solid wire of the same cross-sectional area. The wires are stronger and provide more durability than the solid wires and have better conductivity than the solid wire. Further: Stranded wire is more reliable as it comprises of many strands.
What size wire do I need for a 100 amp underground 150 ft run?
Quote from the video:
Quote from Youtube video: What size wire do i need to run 100 amp service 150. Feet what is the right wire size for 100 amp service 150 feet distance you should get two over zero awg copper wire or four over zero awg aluminum
How do you install a 100 amp sub panel?
Quote from the video:
Quote from Youtube video: For a 100 amp subpanel. If. You want to be a little bit overkill you can spring for the 4 gauge wire. The 4 gauge copper wire. It's not going to cost you that much extra.
How do you wire a Square D 100 amp panel?
Quote from the video:
Quote from Youtube video: So basically just take the breaker put it into the plastic mounting clip and then you would just take this and press it down onto the contact on the bus bar.
