What causes a high limit switch to trip on a furnace?
A high limit switch will keep tripping due to a dirty flame sensor, short cycling, obstructed airflow, or a defective switch. These lead to overheating within the gas furnace that triggers tripping as a safety measure to prevent fires. Clean and replace dirty and worn-out parts to fix the problem.
What causes a limit switch fault?
Airflow issues usually cause a high limit switch to trip out. With less airflow going through your furnace, the heat exchanger excessively heats up and causes the limit switch to trip. Airflow issues can be caused by many different things such as: Dirty air filter.
Can I bypass a limit switch on a furnace?
Yes, you can bypass the high limit switch for testing.
How do I know if my limit switch is bad?
The most common sign of a malfunctioning limit switch is the continuous operation of your furnace’s blower. Just as the limit switch won’t allow the fan to turn on until the warm air has reached the right temperature, the limit switch also shuts down when the air cools to a certain temperature.
How do you bypass a limit switch?
Quote from the video:
Quote from Youtube video: Make sure you use a piece of shielded wire i saw in a couple videos people actually used a paper clip. Absolutely do not use a paper clip.
How much does it cost to replace a high limit switch?
Average Cost of a New Furnace Limit Switch
You will need to buy a high limit switch that is produced by the same manufacturer as your furnace unit. Depending on who your OEM is, this component could roughly cost you anywhere from $4 to $25.
How do you reset the limit switch on a furnace?
How to Reset a Furnace Limit Switch
- Locate your furnace’s heating duct. …
- Locate the white limit switch. …
- Look at each arm to identify the settings. …
- Identify the component (setting) located in between the two arms. …
- Set the temperature on the middle component to approximately 105 to 115 degrees Fahrenheit.
