How do you put cedar shakes on a hip roof?
Youtube quote:Using a three inch long ring shank roofing nail on each side placing the nails at the nail locator marks the pre-formed hip and ridge shake should be placed with a maximum exposure of 10 inches.
How do you calculate shingles for a hip roof?
How Many Roofing Shingles Do I Need?
- Measure the length and width of each plane on the roof (including dormers) then multiply length times width.
- Add the square footage of each of the planes together.
How many bundles of cedar shakes make a square?
Remember, a good wood shingle roof can last from 25 to 30 years, even up to 50 years in some cases. A standard bundle of white cedar shingles covers 25 sq. ft (2.3 m2) if the exposure is 5 in (12.5 cm). Cedar shingles are measured in squares, 1 square = 4 bundles.
How do you finish the peak of a cedar shake roof?
Lay down a layer of shingles with a second layer over the top until the shingles meet at a single, straight peak. Cover all of the nail heads with roofing cement. Cover the length of the cedar shingle roof peak that the new layers of shingles have made. This creates a waterproof seal over this rough roof peak.
How much do you overlap cedar shingles?
Cedar shingles should lap at least 18 cm (7 in.) over each side of valley flashing.
What is the lifespan of a cedar shake roof?
30 years
As long as it’s properly installed and with proper maintenance, you can expect to get 30 years of life out of your cedar shake roof. If you invest in quality materials and live in an area with the right conditions, you could possibly get up to 50 years out of it.
How do you use cedar shakes?
Youtube quote:One. Put two nails per shingle. About an inch and a half above.
What is the difference between wood shingles and shakes?
Wood shingles are sawn on both sides and are thinner at the butt end when compared to a wood shake. Wood shakes are typically sawn on one side and hand split on the other side, making them thicker than wood shingles. Both are wedge shaped and are affixed individually to a roofing deck.
What is skip sheathing?
Skip-sheeting, or spaced sheathing, is just as it sounds: sheathing with gaps between. Traditionally, skip-sheathing consists of 1 inch by 4 inch boards nailed to the rafters with gaps between the boards. Spacing between boards is optimal for wood shakes but cannot support asphalt composite shingles.
What is the minimum overlap for roofing over valley flashing?
Overlap each piece of flashing by at least 6 inches (150 mm). First, apply asphalt plastic cement under the overlap area, then place and nail down the second piece of flashing.
What is space decking on a roof?
Spaced Sheathing, also called Skipped Decking, refers to the construction details of the substrate which the cedar gets nailed to and thus secured to your home.
Should there be gaps in roof sheathing?
Youtube quote:And as you can see there budded right now we don't want this we want a gap of at least an eighth of an inch for expansion purposes.
How far should roof sheathing overhang rafter tails?
Measure up the rafter 45-3/4 inch from the cut end of the truss tail and snap a line along the trusses. This indicates the upper edge of the first row of roof sheathing—leaving enough overhang that the subfascia and fascia will tuck neatly underneath when the time comes.
What is the maximum gap for roof sheathing?
1/4-inch
The recommended maximum gap between roof sheathing boards for low-quality, 3-tab shingles is 1/4-inch. If asphalt shingles are installed over sheathing with gaps exceeding 1/4-inch, over time, these gaps may telegraph through and become visible.
