When the glass around each burner goes above 150 degrees F, the hot surface light will come on to remind you that the surface is hot. After the unit is turned off, the light will remain on until the area around the burner has cooled to below 150 degrees F.
Why does my hot surface light stay on?
Quote from Youtube video: And an indicator switch the indicator switch is on a separate circuit from the element.
Why is my stove light not turning off?
One such common problem is light bulbs. The oven’s electrical system may have been affected, causing your bulb to never turn off. The solution is relatively simple if you know-how for your oven model. Look up the reset process to reset the electrical system of your oven.
Why wont the red light on my stove turn off?
If the red light remains on, the problem is a short circuit in the control switch that remains connected. If the light is off, then the disconnected control is at fault and must be replaced. Before you continue, disconnect the stove and turn off the breaker again.
How do you turn off a hot surface on a stove?
Quote from the video:
Quote from Youtube video: Move the oven door out of the way carefully pull the cooktop forward to release the front lip from the support bracket raise the front of the cooktop slightly to release the frame sides.
How do you turn off a stove light?
Confirm the window in the room is open and there are no open flames. Turn the gas valve to off. There will be a switch that you can turn from ON to OFF to turn off the stove’s pilot light. There should then be no gas going to the pilot light for the stovetop or for the oven.
How do you replace a surface element switch?
Quote from the video:
Quote from Youtube video: Pull out the switch and transfer the wires from the existing switch to the new switch insert the new switch in the control panel and secure it with the mounting screws.
What does a surface element switch do?
When the switch cycles power to the element to control its heat, the switch opens the contact between L2 and H2 stopping power flow to the element. The contacts between terminals L1 and H1 remain closed the whole time the switch is in an “ON” position.
How do you test an electric stove switch?
Quote from the video:
Quote from Youtube video: The switch can be tested for continuity with a multimeter a continuity test will determine. If there's a continuous path for electricity to flow through.
