How do you change an ABS P-trap?
Quote from the video:
Quote from Youtube video: Place your bucket directly underneath the p-trap. Start with the lock nuts you'll get a little bit of water out remove your first slip joint nut remove your second lock nut.
How do you install a P-trap drain?
Quote from the video:
Quote from Youtube video: Off of the drain assembly pipe coming down to make it all fit so i've got it all dry fitted together i'm going to glue the abs fitting on and then we're going to simply just screw together the pieces.
How do I connect ABS pipe to sink drain?
Quote from the video:
Quote from Youtube video: Using the correct cement is very important this is ABS tubing so ABS cement should be used PVC. And PVC – ABS connections have different cements. Apply a thin even coating to any part of the fitting.
How do you fix an ABS drain pipe?
Quote from the video:
Quote from Youtube video: Let the resin air cure for 24. Hours. If required after your first application is cured you can add more resin to fill any voids or to strengthen the repair.
How do you replace a P-trap in a bathroom sink?
Quote from the video:
Quote from Youtube video: You can replace it fairly easily. Here's what you'll need to begin remove the old drain assembly from the top down. Use your pliers to unscrew any stubborn slip nuts.
How do you replace the drain pipe in a bathroom sink?
Quote from the video:
Quote from Youtube video: First place the plastic container under the sink and drain the p-trap. Use the channel lock pliers to loosen and unscrew the nut at the back of the trap.
Why is my ABS pipe leaking?
Waste lines aren’t pressurized, so when a length of ABS pipe leaks, it’s usually either because a joint wasn’t glued properly or the pipe is under external stress. Because they are used for waste lines, leaks in ABS pipes are often accompanied by sewer odors, so prompt attention is in order.
Does ABS pipe need to be primed?
ABS piping doesn’t require primer, but you should prime both male and female sides of any PVC connections. Ensure a neater job by holding the pipe or fitting so that excess primer drips off instead of running down the side.
Can PVC glue be used on ABS pipe?
For the most part, ABS and PVC are not supposed to be glued together. We’ll turn to the 2020 Minnesota State Plumbing Code for some background on this topic.
How do you remove a sink drain trap?
Quote from the video:
Quote from Youtube video: Slide it off dump the water in. There. Loosen up these nuts now loosen. Them up all the way. And you can leave them right on the pipes. And then you can pull this down dump out a little water.
How do you replace a bathroom sink drain flange?
Quote from the video:
Quote from Youtube video: It's going to keep turning that nut all the way down the flange until it comes all the way down to the bottom. Once you do that then you're gonna have to pull the seal.
How do you remove a bathroom sink drain flange?
Quote from the video:
Quote from Youtube video: Take your pliers loosen the locknut from the bottom. That may take a minute sometimes they're a little bit rusty. Once you get that removed. You'll want to work the drain assembly. Up.
How do you remove an old drain flange?
If you’re removing the entire drain apparatus, including the basket (also known as the flange), insert your drain key or smart dumbbell into the opening. Turn it counterclockwise and continue turning until the drain flange is released, then remove the flange while it’s still attached to the drain key.
How do you replace a sink flange?
Quote from the video:
Quote from Youtube video: It's basically just like modeling clay you're going to rip a chunk out start rolling it up get it a little warm in your hands. And you're going to roll. It.
How do I remove a lift and turn drain stopper?
Quote from the video:
Quote from Youtube video: Well try not to loosen the the top of it. But as you rotate counterclockwise the stopper itself will loosen from its base as you'll see here.
