How do I unscrew the drain in my bathroom sink?
Quote from Youtube video: Using your rag place it in your hand and grip the p-trap. Now grip the other side and you're doing this so you don't actually snap the pipe. And just turn it loosen up a little bit now do the other.
How do you remove a sink trap without a wrench?
Unscrew the nuts holding a plastic P-trap by hand, gripping the trap firmly with one hand and rotating each nut counterclockwise. You must unscrew two nuts to remove the trap. One holds the trap to the tailpiece, the small length of pipe extending down from the sink, and the other holds the trap to the drain line.
How do you unscrew a drain pipe?
Quote from the video:
Quote from Youtube video: Use your pliers to unscrew any stubborn slip nuts.
How do you loosen tight plastic plumbing fittings?
Quote from the video:
Quote from Youtube video: So you want to grip it just enough that you have a hold on it. Then I take my pair of pliers. And I'll grip the other one and just give it a little twist. And they should come right apart.
How do you loosen a metal P-trap?
Hold the P-trap pipe steady with a second pipe wrench. Turn the nut counterclockwise until it turns by hand. Pull the nut away from the house drain. Loosen and remove the nut holding the top of the P-trap to the bottom of the tailpipe, using both pipe wrenches.
How do you remove a glued P-trap?
Quote from the video:
Quote from Youtube video: There's a little bit of water in this trap. So why don't you loosen this plug at the bottom just to get it out let it drip into the pan. And just crack it gently.
How do you loosen a tight faucet nut?
This Old House’s plumbing and heating expert, listed in order from easiest to difficult.
- Tighten the nut. Moving the nut in any direction is progress. …
- Tap with a hammer. Jarring the nut can break its bond to the bolt. …
- Apply heat. Metal expands slightly when hot, which may be enough to crack the nut free. …
- Soak the nut.
How do you release plastic pipe fittings?
Quote from the video:
Quote from Youtube video: Ok it's locked you can't pull that out. If you want to get that out just pull that in and put it out and really that's about it with plastic pipe fittings nice and easy saves a lot of grief.
Is plumbing righty tighty lefty loosey?
Lefty Loosey, Righty Tighty.
Turning to the left loosens the plumbing fitting; turning to the right tightens it. Remembering this simple rhyme can prevent a bad seal and stripped fittings. It’s also handy in a pinch if you need to shut off the water supply quickly.
How do you remove a metal pipe from a sink?
Locate the large nut connecting the trap to the straight section of pipe that extends down from the sink, called the tailpiece. Turn it counterclockwise to unscrew it. If it’s plastic, you can often do this by hand; if it is metal or difficult to turn, use a pipe wrench or adjustable pliers.
How do you unscrew galvanized pipes?
Quote from the video:
Quote from Youtube video: You can take the sawzall. With a metal cutting blade it will cut through that galvanized pipe. And get that about the two or three inches from the where.
How do you remove an old galvanized drain pipe?
Quote from the video:
Quote from Youtube video: I have wd-40 by now you can use any type a lubricant. And you wanna use it and you wanna let it sink into the stretch. That are here we want to avoid breaking.
How do you remove a threaded fitting pipe?
Quote from the video:
Quote from Youtube video: Hold it in one hand and twist the tool clockwise with the wrench. And it should just loosen. So that's it next time you have a stuck pipe nipple try using an internal pipe wrench tool to remove it.
