Use an adjustable wrench or adjustable pliers to unscrew the clean-out plug from a P-trap. Place a bucket under the trap to catch the water that will spill out when you remove the plug. Turn the plug counterclockwise to remove it, install the replacement, and turn it clockwise to tighten it.
How do you remove an old P-trap?
Quote from Youtube video: Place your bucket directly underneath the p-trap. Start with the lock nuts you'll get a little bit of water out remove your first slip joint nut remove your second lock nut.
How do you get a clean out plug out?
Loosening a Stuck Cleanout Plug with a Hammer and Chisel
If the plug remains stubborn, place a cold chisel on one edge of the nut and tap it firmly counterclockwise with a ball-peen hammer. Then move to the next face. Continue hammering until the stuck cleanout plug is loose enough to turn with a wrench.
How do I unscrew my sewer clean out?
Removing a Stuck Sewer Cleanout Cap
- Heat the plug to loosen the threads. …
- Tap the fitting around the perimeter of the plug with a heavy hammer, such as a framing hammer or small sledgehammer. …
- Fit a pipe wrench around the nut on the end of the plug and try turning the nut counterclockwise.
How do you remove a P-trap without a wrench?
Unscrew the nuts holding a plastic P-trap by hand, gripping the trap firmly with one hand and rotating each nut counterclockwise. You must unscrew two nuts to remove the trap. One holds the trap to the tailpiece, the small length of pipe extending down from the sink, and the other holds the trap to the drain line.
What to do if P-trap is glued?
Cut two sections of PVC pipe (5 inches or longer) that are the same diameter as the existing pipe. Remove burrs. Apply PVC primer to one outside end of both pipes and the inside ends of a new P-trap. Apply PVC cement to all primed areas and push the cemented pipe ends into the ends of the P-trap.
How do you remove a rusted plug?
Quote from the video:
Quote from Youtube video: We're going to take some wax. And apply the wax to the. Plug. Apply the wax and then as soon as you applied the wax. Careful it's hot but you should be able to now turn.
How do you remove a P-trap from the wall?
To remove the P-trap from the wall stub, hold the trap assembly firm with one hand and turn the coupling nut counterclockwise with respect to the wall stub until it comes loose. If the nut is overtightened or old, you might have to use a wrench or a pair of pliers for the purpose.
How do you loosen a stuck plastic pipe fitting?
Quote from the video:
Quote from Youtube video: So you want to grip it just enough that you have a hold on it. Then I take my pair of pliers. And I'll grip the other one and just give it a little twist. And they should come right apart.
What dissolves PVC pipe glue?
acetone
Apply a small amount of acetone-based nail polish remover with a clean soft cloth. Dab sparingly on the area. Be sure not to soak it. Remove the loosened glue gently and repeat the process a few times if required.
What solvent softens PVC?
We concluded that a 50% solution of acetone rapidly softens PVC and that a longer-term study would better define the ef- fects of lower concentrations.
How do you get PVC pipe apart after glued?
Quote from the video:
Quote from Youtube video: When you found the right one heat it thoroughly for around one minute and put it inside the pipe as such. What this does is it heats up the glue just enough for the pipe to unstick.
