How do you wire a Lutron motion sensor light switch?
Quote from the video:
Quote from Youtube video: Push the wires back into the wallbox. And mount the occupancy sensor to the wall box using the screws that came with the sensor tighten the screws until the sensor is tight against the wall.
How do you wire a 3-way Lutron motion sensor switch?
Quote from the video:
Quote from Youtube video: First all the white wires. Together. Next i'm going to splice. My traveler wire the black traveler wire with the red wire on the 14-3.
How do you wire a sensor switch?
Quote from the video:
Quote from Youtube video: And then after you've turned off the circuit breaker then you need to check to make sure that the power is in fact. Off. Now we know that the power is off we can remove the switch from the wall.
How do you connect a occupancy sensor to a switch?
Quote from the video:
Quote from Youtube video: Now for the occupancy sensor you might have to depending on how it comes in the package. You might need to loosen up these a little bit and ideally.
Does a motion sensor switch need a neutral?
Picking a Motion Sensing Switch. The most important consideration is the necessity of a neutral wire. Some motion-sensing switches require that there be a neutral (white) wire attached to them, some do not—for those that do there is no substitute.
How do you wire a light sensor?
Connect the black, white, and red wires from the light sensor to the wall wires. Twist the hot black wires together and screw a plastic wire nut onto the ends. Repeat this for the neutral white wires and red load wires. The live and neutral wires are always black and white, respectively.
How do you install a Lutron Maestro 3-way switch?
Quote from the video:
Quote from Youtube video: With the power off at the breaker pull the switch you are replacing away from the wall. Before disconnecting your old device look at the screw colors on the side of the switch.
How do you wire a Leviton 3-way switch?
Quote from the video:
Quote from Youtube video: Start by making sure the wires are straight and stripped according to the script gauge located on the back of the device.
Can you put 2 motion sensor on a three-way switch?
When using in a 3-way application use one sensor and one standard 3-way switch. Cannot be used with another sensor, or in a 4-way application. WARNINGS AND CAUTIONS: If you are not sure about any part of these instructions, consult an electrician.
How do you wire a PIR sensor with a light switch?
Quote from the video:
Quote from Youtube video: So the first thing to think about with a PIR generally there's four connections. There's usually a a supply supply live connection a switch live connection.
How do you wire a Lutron Maestro motion sensor switch?
Quote from the video:
Quote from Youtube video: Control. Connect the ground or green wire and a bare wire from the control to the ground wire the green or bare wire in the wallbox connect. The two black wires to the two wires in the wall.
Will motion sensor work without ground?
The neutral is required to power the motion sensor and solid state timer. It cannot function without at least 1 hot and one neutral. Since all neutrals should be joined in the breaker box to one terminal block, any neutral in the house will work.
